Slurry Pump Spare Parts That Fit and Last
Wet-end parts wear from abrasion and are designed to be replaced: impeller, volute liner, throatbush, frame-plate and cover-plate liners, expeller ring, shaft sleeve, gland, packing and bearing assembly.
What We Supply as Loose Parts
Every wetted component in the slurry pump range is available on its own, not only as part of a complete unit. That covers impellers, volute liners, throatbushes, frame plate liners and cover plate liners, expeller rings, shaft sleeves, glands and packing rings, together with pump bodies, covers, shafts and both packing and mechanical seal assemblies. Ordering singly matters in this duty because wear is never even: the throatbush and impeller usually go long before the casing does.
Pumps in This Range
Impeller — Slurry Pump ImpellersForward adjustment restores clearance and recovers efficiency.
Liner / Volute CasingThroatbush wears first; other patterns indicate duty drift.
Expeller — Expeller Rings and Dynamic SealDynamic seal that needs no gland water supply.
Bearing AssemblySealed cartridge; grease charge set by frame type.
Shaft Seal — Expeller, Packing and MechanicalExpeller, packing and mechanical — each with a defined operating limit.
Material Options and Where Each Belongs
Parts are produced in high-chrome alloy, ceramic, polyurethane, natural rubber and synthetic rubber, and in metal, rubber or ceramic composite builds. High-chrome suits coarse, high-impact abrasive service. Rubber suits finer particles and mildly corrosive duty but dislikes sharp angular solids. Polyurethane sits between the two on fine abrasive work. Ceramic is chosen where erosion dominates and impact is low. Tell us the particle shape as well as the size, since shape is often what decides between metal and rubber.
Matching From a Sample or Drawing
Parts can be produced from your sample or from a drawing, and OEM work is supported. Individual part dimensions and tolerances are confirmed on request before anything is cut. Where you are replacing wear parts in an existing installation, send the pump size and duty alongside the sample so the replacement is matched on fit and on service conditions rather than on outline alone.
Planning Replacements
Wear parts are best ordered against a known change interval rather than after a failure, because a worn throatbush pulls efficiency down long before it fails outright. Lead time and minimum order quantity are quoted per order and differ between wear parts and complete pump sets.
Send Your Enquiry
Slurry Pump Bearing Assemblies
Slurry Pump Expeller Rings
Slurry Pump Impellers Engineered to Outlast the Duty
Slurry Pump Liners & Volute Casings
Slurry Pump Shaft Seals
Wholesale & OEM Slurry Pump PartsDo you supply wet-end wear parts (impeller, liner, throatbush, expeller) separately?
Yes. Impellers, volute liners, throatbushes, frame plate liners, cover plate liners, expeller rings, shaft sleeves, glands, packing rings, pump bodies, pump covers, shafts and packing or mechanical seals are all supplied as separate items. Materials include high-chrome alloy, ceramic, polyurethane, natural rubber and synthetic rubber, as well as metal, rubber and ceramic composite builds.
Can you reverse-engineer a part from my sample or drawing?
Yes. Parts can be matched from your sample or drawing, and OEM work is supported. Individual part dimensions and tolerances are confirmed on request.
What is the lead time and MOQ for spare parts compared with complete pumps?
Lead time and MOQ are quoted per order on request, and differ between wear parts and complete pump sets.
Manufacturer-direct supply · Technical pump-selection support · Export documentation on request.
